The Freyr is a dual-switch torch producing both white light and RGB lights. It is a very distinctive multi colour torch, wich is able to offer white, red, green and blue outputs for different needs.
Besides high performance cool white LED. There are RGB LEDs consisting of a 635 nm red LED, a 515 nm green LED and a 470 nm blue LED. They are all high efficiency enough.These three colored lights (red, green, blue) are helpful for night vision protection, investigation, or signaling and so on. There is always a colour you can use. Freyr has two independent switches. You can select a coloured light or moonlight easily with the side switch, or operate the white light tactically with the tail switch, which is also an interface with the magnetic charging cable. So a single half press of the tail switch turns on white low and a full press turns on white high. The momentary operation is also possible in high and low by holding the button instead of releasing, with the light turning off once released. A single press of the side switch will turn on in the last used colour or moonlight, and once on hold down the button to cycle through red, green, blue and white moonlight outputs. Moonlight can also be directly accessed by holding the side switch for over 1 second from off. A quick double click of the side switch gives instant access to the high white mode, and another double click will cycle to low white mode. Three quick presses will activate the white strobe mode and a single press will exit.
1750 Lumens +360-Meter Beam Throw
Besides a colour torch, the main white light boasts a maximum output of 1,750 lumens and a beam distance of up to 360 meters. This has met the requirements of a tactical torch in fact. Bright enough and far enough to provide the brightness and line of sight you need when you're out or in tactical needs.
Tactical and Traffic Use
With a silicone traffic wand, it also can be used to direct traffic, mark a potentially dangerous area, etc. Please note that the torch should only be used in moonlight or low when using the silicone traffic wand. There is also a proximity sensor under the front lens that will lower the output of the Freyr if it becomes close to an object. This will prevent the high output from causing some danger or damage to the torch. It is a security setting to protect yourself and your torch. However, the sensing distance is between 3 cm and 50 cm, depending on the reflectivity of the obstacle. And the proximity sensor will not work if there is dust, water, or scratches on the front lens.
Lockout function will prevent the torch from being accidentally activated. If you want to lock your torch, just need to press and hold the side switch for 2 seconds. To exit lockout you need to press and hold the button down for over 1 second.
Powered by a 5000mAh rechargeable lithium-ion battery, which is recharged inside the torch using the included MCC3 magnetic charging cable. Just attach the magnet to the Freyr's base, then plug the USB end into a suitable power source using a suitable USB adapter (2A is the fastest charging). The indicator light on the magnet will turn red when charging, if the power supply is enough to support 2 A output, it will turn green after charging is complete after about 5 hours. If the cable output is at a lower rate or 1 A or 1.5 A, the time to charge will also be longer.
1750 lumens; 2 minutes run-time; 360 m beam range
850 lumens; 2 hours, 30 minutes run-time
300 lumens; 28 minutes run-time
300 lumens; 9 hours, 30 minutes run-time; 150 m beam range
• Moonlight: 5 lumens; 15 days run-time; 19 m beam range
• Red: 30 lumens; 20 hours run-time; 12 m beam range
• Green: 60 lumens; 14 hours run-time; 19 m beam range
• Blue: 25 lumens; 12 hours run-time; 8 m beam range
*The turbo setting will drop down twice as shown above to prevent the LED from overheating
FREYR ORANGE - MULTI-COLOURED TACTICAL LIGHT
ALL OLIGHT TORCHES ARE TESTED TO ANSI/NEMA FL1-2009 STANDARDS.
|Freyr User Manual.pdf||5206kb||Preview|